The installation method and inspection method of pump pipe and drive shaft of deep well submersible pump

What is the installation method and inspection method of pump tubing and drive shaft of deep well submersible pump?welcome to wholesale qj deep well submersible pump.
Deep well submersible pumps are installed as follows:
    ① lift the pump under the short tube, hanging on the board should be sliding on the board or with a rope to lift the end of the tube, so that it does not contact with other objects to protect the pipe end thread from damage. When lifting the pump pipe, apply the rope to tighten the drive shaft so that it does not fall. Do not use the hand drive shaft to prevent the transmission shaft from bending.
    ② After lifting the pump tube, it should be on the same axis as the pump section. The end of the shaft shaft rotation in the pump section of the shaft end of the thread, the shaft should be spin to the middle of the distal end of the shaft, and add a very small amount of lubricating oil for lubrication purposes, excessive lubricants will bring harm to the rubber bearings. Slightly lower the pump tubing, loosen the drive shaft to fasten the rope and screw the shaft end of the drive shaft into the axle section mounted on the shaft end of the pump until the two drive shaft ends are in contact with each other. Down the pump tube, the pump pipe screw into the pump section tube, with a chain clamp tightening.
    Slightly lift the pumped parts and release the lower splint and carefully lift the pump into the well until the pipe clamp rests on the square.
    ③ In accordance with the above method, the pump pipe and the drive shaft are installed on a row-by-block basis until the pump tubing is installed.
    Vertical Deep well submersible pump inspection method:
Inspection of pump tubing and pump shaft installation In order to ensure the installation quality of pump tubing and pump shaft, the position of the drive shaft and the length of the drive shaft protruding from the tube bundle should be checked step by step in the installation of each pump and pump shaft If the drive shaft is not deformed by external force, its position should be on the center line of the pump pipe. According to the length of the drive shaft out of the tube dome, it can be determined whether the end of the drive shaft and the pump pipe end face are closely connected The
    You can also check the following: After each pump tubing and drive shaft is installed, you can use the tool (or by means of a tool) to rotate the drive shaft to see if it can be turned. If the installation of a sudden feeling of the drive shaft after the friction increased more, or even difficult to turn, indicating that the pump tube and drive shaft is not installed, it should be opened, check the reasons after the re-install until the request so far The